Making scale parts

The guys down at the track I go to are also into CC01 based scale crawlers, so I dusted off one or two of mine and set to making some scale parts for them.

I started off making an interior for my Land Cruiser.
It’s made from 1mm plastic board, 5mm plastic round stick and glue. The steering wheel is from an Axial wraith kit and the driver is a Wrestling figure.

Next, I had a go at making a roof ladder and rack for the Pajero, again, using 5mm plastic round and square.


All these parts were made without plan, I just thought about the shape in my head and then started cutting parts out. I’m sure they would look a lot better if I planned them out properly.

Advertisements